Rivet can make any hat buttons alpha or ring button..

rivet from a button with a diameter of 10mm.

   Take the hat from the button with a diameter of 10 mm and carnations for rivet.

As the diameter of the tube caps button is smaller than the diameter cloves, slightly increase the diameter.
Then the standard installation process rivet.
I recommend to install the rivets on products made of relatively thin fabric.

Rivets from the button with a diameter of 12.5 mm

For heavier fabric and leather use hats buttons with a diameter of 12.5 mm and a denim carnations.

    The top of the nozzle to polytene diameter 9 mm, bottom from set to set buttons with a diameter of 12.5 mm Tube cap button is slightly less than the diameter denim cloves, slightly expandable hole
Installation scheme:
The hat is inserted into the tissue (skin) and hold down press
Rivet ready.
View from the front side       

The view from the inside
Example: Set decorative polyteny on womens boots (to fix the marriage of the manufacturer) 
Use buttons with a diameter of 12.5 mm and a shorter aluminum carnations for rivet. First: from the inside of the boot cloves smooth and will not cling stockings, second: they are well fixed in the tubular portion of the cap button, third: a lot of them and somewhere you want to attach.

Example: Setting buttons - rivet clothing.
You can also use part D button alpha diameter 12.5 mm. to install rivet diameter of 9mm and spherical.

Need to slightly enlarge the hole in the cap of rivet. Next install in the usual manner.

Rivets of buttons with a diameter of 15mm.

- Exactly the same job and with the hat buttons with a diameter of 15 mm. The bottom nozzle of the buttons with a diameter of 15 mm, the Upper part is for rivets with a diameter of 9 mm Or lower part of the same, the top ordinary disc - guide   Carnations are taken from the rivets with a diameter of 9 mm.   He's just fit to tubular base buttons with a diameter of 15 mm.

Installation scheme Next install in the usual manner.
The same rivets can be made from other types of buttons.
Important: watch for alignment during installation hallatrow.

Example setup: 

Rivets button "sphere"

The order for the installation of convex rivets. Use the buttons sphere with a diameter of 10mm as the most suitable color.
Used nozzle MT-1024 and disc adapter.

       The installation produced on aluminum carnations for rivets (2 times shorter denim cloves).

The same scheme can be installed rivets for any product:      Super - clutch